HP MPIO Full Featured DSM for P9000 family of Disk Arrays 4.02.00 installation and reference guide (AA-RVJ6M-TE, October 2010)

DescriptionMessageEvent ID
A new path in excess of the suppor-
ted number of paths for an existing
multipath disk has been discovered.
X represents the serial number of
the disk. Y is the SCSI address of
the newly found path.
Too many paths for disk
with serial number X. Path
(SCSI address Y) not ad-
ded.
303
A redundant path to an existing
multipath disk has failed. X repres-
ents the serial number of the disk.
Y is the SCSI address of the path
that failed.
An unrecoverable path
failure occurred on SCSI
address Y. Disk X is still
accessible over redundant
path(s).
304
The DSM was unable to successfully
throttle I/O activity within the
time-out period, for the specified
multipath disk. X represents the
serial number of the disk.
The DSM timed out on the
I/O throttle operation for
multipath capable disk X.
305
New LUN in excess of the
supported number of LUNs for an
existing HBA to array port nexus
has been discovered. X represents
the serial number of the disk. Y is
the SCSI address of the newly found
path.
Number of LUNs exceeds the
maximum limit supported.
Disk X with path SCSI ad-
dress Y will be ignored.
306
The DSM cannot manage multipath
capable disk X (SCSI address Y)
due to an internal error.
The DSM cannot manage
multipath capable disk X
(SCSI address Y) due to
an internal error.
309
This event is logged when DSM
detects that the path with SCSI
address Y is inconsistent and is
moved to failed state. X represents
the serial number of the disk. A
reboot of the system is
recommended to overcome this
inconsistent state.
The DSM detected an incon-
sistency in the path (SCSI
address Y) to the mul-
tipath capable disk X.
This path has been marked
as failed.
310
HP MPIO Full Featured DSM for P9000 family of Disk Arrays 4.02.00 installation and reference
guide 47