HP MPIO Full Featured DSM for P9000 family of Disk Arrays 4.02.00 installation and reference guide (AA-RVJ6M-TE, October 2010)

hpdsm devices all
Syntax: hpdsm devices all
The hpdsm devices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
HP OPEN-VTotal No. of Devices:2
Active Paths: 2Device#:1
Disk 1Serial No:50 142460C00
ALB:N/APolicy:RR
P.B.T.L:3.1.0.0
P.B.T.LRTPHBA Slot#StateController Port#Path#
1.0.0.0—7Active3A1
4.0.2.0—6Active3A2
HP OPEN-VDevice#:2
Active Paths: 2Serial No:50 142460C01
Disk 2Policy:RR
ALB:N/AP.B.T.L:3.1.0.1
P.B.T.LRTPHBA Slot#StateController Port#Path#
1.0.0.1—7Active3A1
4.0.2.1—6Active3A2
Managing storage arrays using the HP MPIO P9000 DSM with the CLI utility28