installation and reference guide HP MPIO Full Featured DSM for MSA1000/1500 (Active-Active) Disk Arrays 3.02.00 (AA-RW8AF-TE, March 2009)

N/A3.1.3.3Disk 3SQB2600508B300912160ACA7F3631676001C
HP
MSA_VOLUME
3
N/A3.1.3.4Disk 4
SQR—
Subset
2600508B300912160AAA7E3672638001B
HP
MSA_VOLUME
4
N/A3.1.3.5Disk 5
SQST—
Subset
2600508B300912160A0C7936B297F001D
HP
MSA_VOLUME
5
N/A3.1.3.6Disk 6SQST2600508B300912160AD87836F3945001C
HP
MSA_VOLUME
6
hpdsm devices all
Syntax: hpdsm devices all
The hpdsm devices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
Total No. of Devices:2
HP MSA_VOLUMEDevice#:1
Active Paths: 2Serial No:6005008B5009013F0AA40492A2BE801B7
Disk 1Policy:NLB
ALB:N/AP.B.T.L:3.0.0.12
P.B.T.LRTPHBA Slot#StateController Port#Path#
*
3.0.0.12000100017ActiveP56350GX3R10F6-11
4.0.0.12000100026AvailableP56350FX3RQA03-12
HP MSA_VOLUMEDevice#:2
Active Paths: 2Serial No:6005008B5009013F0AB40492A2BE801B8
Managing storage arrays using the HP MPIO MSA DSM with the CLI utility26