Setup and Install

Configuring HP WebQoS
Configuring WebQoS from the Management User Interface
Chapter 3 71
Figure 3-22 Add Thresholds Dialog Box
a. In the Add Thresholds dialog box (Figure 3-22, "Add Thresholds
Dialog Box"), select the Threshold type from the pull down menu.
For specific information on the threshold policies supported by
WebQoS, see “Threshold Policies” on page 159.
b. Enter an appropriate percent in the Percent input box.
c. Select the Class from the pull down menu, if applicable.
d. Enter the appropriate Threshold Priority. The threshold
priority defines theorder in which the thresholds are checked. The
order is compared to both threshold policies and SLO priorities.
The thresholds are prioritized in ascending order (from lowest to
highest) meaning a priority 1 threshold or SLO is higher in
priority than a priority 2 threshold or SLO.
When multiple thresholds and SLOs are violated, the corrective
action with the highest priority is taken. The highest priority
starts at one.