Setup and Install

Conﬁguring HP WebQoS

Running the WebQoS setup Script

Chapter 3 39

If you do not want to conﬁgure any web servers, enter NONE.

• Do you want to remove HP Admission Control?

This question appears only if you have installed an older version of

WebQoS (HP ServiceControl) on your system. You must remove HP

Admission Control in order to use this version of WebQoS. If you

answer no, you will exit the script and you will not be able to use this

version of WebQoS.

• Log the service statistics to MeasureWare?

This questions appears only if MeasureWare is already installed on

your system.

WebQoS has been integrated with some components of HP OpenView.

If you would like to view WebQoS reports, statistics, graphs, and

events in HP OpenView, answer yes.

The setup script also starts the Service Control Agent.

Running setup -r

If you decide you no longer want to use WebQoS with your web server,

run the following command.

/opt/webqos/install/setup -r

WebQoS conﬁguration data is preserved in case you want to run WebQoS

again later.

When you run setup -r, you must provide the following information:

• Continue running or exit the script?

If you want to continue using WebQoS, you can exit the script now.

• Select the type of web server on which you no longer want to use

WebQoS.

Choose either NES (Netscape Enterprise Server) or Zeus.

• Enter the root pathname of the web server.