Setup and Install

Configuring HP WebQoS
Configuring Your Web Server
Chapter 334
Configuring Your Web Server
This section lists required and optional parameters that can be
configured for your web server.
Zeus Web Server
Configuring Zeus Web Server Parameters
You must configure the following Zeus web server parameters with the
given values in order to use WebQoS successfully. Each parameter is
formatted as follows:
parameter_name: given_value
In $ZEUSHOME/webadmin/config/sites/ virtual_server , for each
IP-based virtual server, configure the following parameter (this
parameter can also be configured by modifying the Bind address field in
the General Server Configuration screen of the Zeus web
administration server for each IP-based virtual server):
• bindaddr: IP address of the IP-based virtual server
The IP address assigned to the IP-based virtual server.
Used with the tuning!bind_any parameter, this parameter allows
you to configure WebQoS individually for each IP-based virtual server
(you can configure each IP-based virtual server as an individual site
in WebQoS).
If this parameter is not configured, WebQoS can only be configured
globally for all virtual servers (you must configure all virtual servers
as one site in WebQoS).
In $ZEUSHOME/web/global.cfg, configure the following parameters:
• tuning!bind_any: no
Do you want to bind the virtual server with any IP address?
If the bindaddr parameter is configured and this parameter is set to
no, the web server can bind a specific IP address with each IP-based
virtual server. This allows you to configure WebQoS individually for
each IP-based virtual server (you can configure each IP-based virtual
server as an individual site in WebQoS).