Setup and Install

Installing and Using HP LocalDirector Controller
Configuring HP LocalDirector Controller
Chapter 6 149
Configuring a System with More than One LAN Card
If the system on which you are running the web server has more than
one LAN card, you must set the snmp-server host and real
parameters in Cisco LocalDirector. Do the following:
1. On the system with multiple LAN cards, run netstat -rn and check
the routing table information. Use the IP address associated with the
Cisco LocalDirector gateway to configure the snmp-server host
parameter of Cisco LocalDirector.
2. On the system with multiple LAN cards, run
nslookup local_hostname and use this IP address to configure the
real parameter of Cisco LocalDirector.
Refer to Cisco LocalDirector’s manuals for information on setting these
parameters.
Troubleshooting the HP LD Controller
General Troubleshooting
If an error occurs, check the following two log files for error messages,
causes, and recommended actions:
1. /var/opt/hpldc/ldc.log
2. /var/opt/hpldc/webstone.log
HP LDControl Cannot Find Cisco’s LocalDirector
If HP LocalDirector or the snmp_test program does not find the correct
IP address for the system connected with Cisco’s LocalDirector, edit the
/opt/hpldc/webstone/conf/server-list file to include this IP
address.
For example, if the IP address of the system running Cisco’s
LocalDirector is 111.222.333.444, change the entry in the server-list
file to:
111.222.333.444 / web_srvr_root web_port_number / web_srvr_root / document_root