Setup and Install

Installing and Using HP LocalDirector Controller
Installing HP LocalDirector Controller
Chapter 6 141
HP LDC adjusts the weights depending on CPU usage and system load.
Both the CPU usageand system load (measured by a one minute average
job queue) must reach their configured thresholds before the weights are
lowered. The weights will range between one and the initial weights.
Installing HP LocalDirector Controller
Before installing the HP LDC software, you should do the following:
• Check that your system meets all the necessary prerequisities. Refer
to “Check System Prerequisites” in the HP WebQoS Premium for
HP-UX Release Note.
• Check if you need to install patches. Read the HP WebQoS Premium
for HP-UX Release Note.
• Read the following HP LocalDirector Controller README file:
/opt/webqos/admserv/README.LDC
Installing the Software
To install HP LDC, run swinstall (as root), double-click on the WebQoS
bundle to view the software, and select the HP LDC software.
After installing both HP LDC and HP WebQoS, run
/opt/webqos/admserv/setup to set the password that you will use to
configure HP LocalDirector.
Configuring Cisco LocalDirector
Because HP LocalDirector Controller sends information to Cisco
LocalDirector using SNMP traps, the snmp-server host parameter
must be configured in the Cisco LocalDirector.
On a system managed by Cisco LocalDirector, run netstat -rn and
check the routing table information. Use the IP address associated with