User's Manual

Other Ways to Create a Configuration Template
●
In the left navigation pane, right-click on Configuration and select Create configuration template.
●
In the left navigation pane, expand Configuration and right-click Templates. Then select Create
configuration template.
●
In the Configuration - Templates task module, select Create.
●
In the left navigation pane, right-click on Overview and select Configuration > Create configuration
template.
●
In the left navigation pane, expand Configuration and select Templates. Click Create next to the list of
templates displayed.
●
In any device list, select one or more devices and click the Config tab at the bottom of the page. Select
the configuration options and then click Save as Template.
Edit a Configuration Template
●
Steps to Edit a Configuration Template
●
Other Ways to Edit a Configuration Template
You can make changes to any configuration template after is has been created.
Steps to Edit a Configuration Template
1. In the Device Management navigation pane, right-click Configuration, and then select Edit
configuration template. The Edit Device Configuration Template wizard starts.
2. On the Select template page, select the template, and then click Next.
3. On the Select Template Models page, change the device models and network cards included in the
template, and then click Next.
NOTE: If you change the device models and network cards included in the template, any configuration
settings you already specified for the template might be lost. If you remove any device models or
network cards, some configuration options might no longer be available. If you add device models or
network cards, new configuration options might now be available.
4. On the Specify template options page, enter a new name for the template (up to 48 characters).
5. Specify the settings for the configuration options to include in the template, and then click Next.
NOTE: For information about specific configuration options that might not work properly in a batch
mode, see
Captured Configurable Options and Configuration Templates on page 170.
NOTE: The configuration options selected for this template will only be applied to those devices that
support the options.
6. On the Confirm page, verify that the configuration option settings are correct, and then click Save
Template.
7. On the Results page, click the Done button.
Other Ways to Edit a Configuration Template
●
In the left navigation pane, right-click on Configuration and select Edit configuration template.
●
In the left navigation pane, expand Configuration and then expand Templates. Right-click on the
template to edit and select Edit configuration template.
172 Chapter 3 Device Management ENWW