User's Manual

To print a demo print, tap , then scroll down and tap Internal prints, then Demo prints, and select a print.
The following prints are available:
● Render
● CAD black & white
● GIS
Congure your printer
Connect the printer to your network
The printer is able to congure itself automatically for most networks, in a similar way to any computer in the
same network. The rst time you connect it to a network, this process may take a few minutes.
Once the printer has a working network conguration, you can check its network address from the front panel:
tap
.
TIP: Consider making a note of the printer’s IP address, because you may need it during the setup process of
connecting your Windows or macOS computer clients.
Modify network conguration
To modify the current network conguration, go to the front panel and tap , then , then Network >
Gigabit Ethernet. From here it is possible, though not normally necessary, to change the settings manually; this
can also be done remotely using the Embedded Web Server.
For full details of the available connectivity settings, see Networking on page 51.
If you accidentally miscongure the printer’s network settings, you can restore the network settings to their
factory values from the front panel: tap , then Network > Restore factory settings. Then you must restart
the printer. This automatically provides a working network
conguration for most networks. The printer’s other
settings remain unchanged.
Install your printer under Windows
The following instructions apply if you intend to print from software applications using a printer driver. See
Printing on page 59 for alternative ways of printing.
16 Chapter 1 Introduction ENWW