WBEM Profiles Guide
Version 2.0.0 47
7.10.3 HPSA_ISASPort.UsageRestriction
A LogicalPort might be identifiable as a front end or back end port. If there is no restriction on the use of
the port, then the value should be set to 'not restricted'. Value is set to 4 (Not restricted) for initiator port.
7.11 HPSA_ SCSIInitiatorTargetLogicalUnitPath
The HPSA_SCSIInitiatorTargetLogicalUnitPath class has been extended from
CIM_SCSIInitiatorTargetLogicalUnitPath to represent a path between a SCSI initiator, target, and logical
unit..
7.11.1 HPSA_ SCSIInitiatorTargetLogicalUnitPath.Initiator
This value is a reference to an instance of HPSA_ISASSCSIProtocolEndpoint.
7.11.2 HPSA_ SCSIInitiatorTargetLogicalUnitPath.Target
This value is a reference to an instance of HPSA_TSASSCSIProtocolEndpoint.
7.11.3 HPSA_ SCSIInitiatorTargetLogicalUnitPath.LogicalUnit
This value is a reference to an instance of HPSA_StorageExtent.
7.11.4 HPSA_ SCSIInitiatorTargetLogicalUnitPath.State
The state of this path. Values are defined as follows.
Table 31 - HP Smart Array profile: HPSA_SCSIInitiatorTargetLogicalUnitPath.State
Value ValueMap Description
0
Unknown
The path status cannot be
ascertained
2 Active
The path is active and
healthy
3 Passive
Path is healthy but is not
active or is the standby
path
5
Path Error
path has an error
condition
7.12 HPSA_EncProtocolEndpoint
The HPSA_EncProtocolEndpoint class has been extended from CIM_SCSIProtocolEndpoint and
represents the protocolendpoint of an enclosure port. The following properties have been added to
represent the protocol (command set) associated to a target port.
7.12.1 HPSA_ EncProtocolEndpoint.ProtocolIFType
ProtocolIFType is an enumeration that is synchronized with the IANA ifType MIB. Note that if the
ProtocolIFType is set to 1 (Other), then the type information should be provided in the
OtherTypeDescription string property.