WBEM Profiles Guide

Version 1.0.0 13
8 Methods
None.
8.1 Profile Conventions for Operations
Support for operations for each profile class (including associations) is specified in the following sub-
clauses. Each sub-clause includes either a statement “All operations are supported as described by
DSP200 v1.2” or a table listing all the operations that are Unspecified by this profile or where the profile
requires behavior other that described by DSP200.
The default list of operations is as follows:
• GetInstance
• Associators
• AssociatorNames
• References
• ReferenceNames
• EnumerateInstances
• EnumerateInstanceNames
A compliant implementation shall support all the operations in the default list for each class, unless the
Requirements column states something other than Mandatory.
8.2 HP_Processor
The table below lists operations that either have special requirements beyond those from DSP0200 or
shall not be supported. All other operations may be supported as defined in DSP0200.
Table 3 – Operations: HP_Processor
Operation Requirement Messages
GetInstance Mandatory None
Associators Unspecified None
AssociatorNames Unspecified None
References Unspecified None
ReferenceNames Unspecified None
EnumerateInstances Unspecified None
EnumerateInstanceNames Unspecified None
8.3 HP_ProcessorCore
The table below lists operations that either have special requirements beyond those from DSP0200 or
shall not be supported. All other operations may be supported as defined in DSP0200.