Specifications

Chapter 2 71
Parts Replacement Procedures
System Board
6. Install the following components:
See Figure 2-62.
Figure 2-62. B2000 Components
7. Replace the EMI shield(s) and the T-15 Torx screw(s).
8. Replace the left side panel as described in “Closing the Left Side Panel” on page 17.
9. Attach all peripherals, keyboard, mouse, LAN and power to the workstation.
10.Reference Chapter 3, “Wrapping Up,” on page 85 for completion of this procedure.
• Hard Disk Drive(s) and
bracket(s)
“Installing a Hard Disk Drive” on page 45
• Memory Card(s) “Installing Memory” on page 18
• Air Divider “Air Divider” figure on page 72
• PCI cards (if installed) “Installing I/O Cards” on page 28
• PCI retainer clip “Retainer Clip” figure on page 27
• Voltage Regulator Modules
(VRMs)
“Installing VRMs” on page 65
• Power Supply “Installing the Power Supply” on page 61
Power Supply
& VRMs
(hidden from view)
PCI Retainer
Clip
Air Divider
Memory
Hard Disk Drive
Hard Disk Drive
Bracket
Cards
EMI Shields