Specifications

34 Chapter2

Parts Replacement Procedures

CD Drive

5. Remove the CD drive from its shipping container and verify that the jumper on the back of the

CD drive is set to the C Select position. Using the four blank ﬁller screws (T-15 Torx/slotted

screws) that were just removed, mount the disk drive to the bracket as shown in Figure 2-22.

Note that the CD drive should extend approximately one inch out from the front of the CD drive

bracket.

Figure 2-22. Installing the CD Drive

6. Slide the CD drive and its bracket into the workstation chassis as shown in Figure 2-22.

There are runners on the side of each bracket and guides inside the CD drive chassis

that will help the assembly to slide into place.

Blank Filler Screws

Bracket Screws

CD Drive Bracket Guide

CD Drive