Specifications

18 Chapter2
Parts Replacement Procedures
Memory DIMMs
Memory DIMMs
This section describes how to remove and replace the Memory DIMMs for the B2000
workstations.
Installing Memory
Perform the following steps to add memory (DIMM cards) to your workstation.
WARNING Turn the workstation off and unplug the power cord before
installing additional memory. Reference “Safely Powering Down the
B2000 Workstation” on page 12.
CAUTION To prevent damage to the B2000 workstation, observe all of the ESD
precautions as described in the “Electrostatic Discharge (ESD) Precautions”
on page 9.
1. Open the side panel of the workstation as explained in the section “Opening the Left
Side Panel” on page 16 in this chapter.
Figure 2-3 View of System Board
Power Supply
DIMM Card
DIMM Connector
B2000 System
Label