Technical data

Chapter 2 51
Installing HP-UX
Viewing or Modifying Configuration
• Initializing a disk ("mediainit") is both time consuming and generally
unnecessary, except in the unlikely event that the disk has incurred
low-level formatting damage due to a control malfunction.
If necessary, make any modifications and tab to OK. Then press Enter.
Modifying Volume
Group Parameters
If you selected Modify Volume Group Parameters (LVM only) in the
screen shown in Figure 2-17, you will see a screen similar to the
following:
Figure 2-19
If necessary, make any modifications and tab to OK. Then press Enter.
After you have viewed or modified the parameters in each sub-screen,
you will see the Specify Disk Usage Screen (Figure 2-17) again
summarizing the current status of disk usage.
Configuring File
Systems
If you selected Modify (FS) Parameters in the screen shown in Figure
2-16, you would see a screen similar to the following: