Technical data

40 Chapter 2

Installing HP-UX

Installing and Conﬁguring the Operating System

If you plan to use a network software depot to load the operating

system, you will need to enable networking at this time.

Would you like to enable networking now?[y]

Answering "n" means that you intend to install entirely from the media

and the Install Kernel continues to load.

Answering "y" brings up the following screen if you have more than one

LAN card:

(If you have only one LAN card, you will see the Network Conﬁguration

screen next (Figure 2-12).

Figure 2-11

1. Choose the LAN interface that you will be using for this installation.

(Note that only Ethernet can be used for installation.)

2. You will next see the following Network Conﬁguration screen. Some

of this information will have been ﬁlled in for you if you have

conﬁgured the Dynamic Host Conﬁguration Protocol (DHCP). See

Appendix B, “Conﬁguring for a DHCP Server,” for more information.

Figure 2-12