Technical data

34 Chapter 2

Installing HP-UX

Booting from Media (All Series)

• If neither the primary or alternate device paths correspond to that

for the CD-ROM device, then respond with "n" to both prompts. In

this case, enter the hardware path of the device (for example,

52.3.0) at the prompt "Enter boot path, command, or ?>".

5. To the question "Interact with IPL (y or n)?", respond with

"n".

After Selecting Boot Paths (Workstations and

Servers)

1. If you see the following question on your screen, type n:

Interact with IPL (Y or N)?> n

2. You can abort the installation at this point, if you wish, by turning

the system off and starting over.

3. When you have chosen the boot path and loaded the Install Kernel,

the system will display the HP-UX Installation Welcome screen.

From this point on, you will respond to the requests for information

on these screens.

Time Note Loading the Install Kernel should take 3 to 5 minutes.

For the remainder of the installation, go to “Installing and Conﬁguring

the Operating System”, in this chapter.