Programming instructions

Chapter 3 71
Troubleshooting
Selftest Failures
TST C680 SYS BD builtin graphics
Look for built-in graphics card.
INI C680 SYS BD builtin graphics
Successfully initialized built-in graphics
card.
WRN C680 SYS BD builtin graphics
Built-in graphics initialization failed.
TST C68
s
SYS BD test graph in
s
Look for graphics card in PCI slot s.
INI C68
s
SYS BD init graph in s
Successfully initialized graphics card in
PCI slot s.
WRN C68
s
SYS BD fail graph in
s
Card in PCI slot s failed graphics
initialization or is not a graphics card.
INI C740 EXT IO init other path
Autoboot is trying to boot from
non-primary boot device.
INI C780 EXT IO ld IPL othr path
Loading IPL from non-primary boot
device.
WRN C7F0 EXT IO other IPL fault
Error loading IPL from non-primary boot
device.
WRN C7F1 EXT IO bad alt IPL read
Cannot load IPL from non-primary boot
device--load address invalid.
WRN C7F2 EXT IO bad alt IPL read
Cannot load IPL from non-primary boot
device--file is not IPL image.
WRN C7F3 EXT IO bad alt IPL read
Cannot load IPL from non-primary boot
device--IPL image size invalid.
WRN C7F4 EXT IO bad alt IPL read
Cannot load IPL from non-primary boot
device--IPL entry point address invalid.
WRN C7F8 EXT IO bad alt IPL read
Cannot load IPL from non-primary boot
device--IPL image checksum failed.
WRN C7FF
<blank>
launch IPL other
Booting from a device other than the
primary boot path.
INI CB00 SYS BD TOC initiated
A Transfer of Control entered the
firmware TOC handler.
WRN CB01 SYS BD no OS TOC vector
There is no TOC vector for the operating
system. Firmware will soft boot the
system.
WRN CB02 SYS BD bad OS TOC addr
The operating system TOC handler vector
is invalid. Firmware will soft boot the
system.
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU Message
Description