Programming instructions

Chapter 3 67
Troubleshooting
Selftest Failures
WRN 80F7 EXT IO boot IO error
Error detected during boot device I/O.
WRN 80F8 EXT IO invalid boot dev
Invalid boot device class; bad IODC?
WRN 80FC EXT IO invalid boot dev
Unexpected error; bad IODC?
INI 8800 IOCARD PCI BusWlk start
Starting PCI bus and device discovery.
INI 88
r
1 IOCARD PCI Rope
r
walk
Starting PCI bus and device discovery on
Rope r.
INI 8802 IOCARD PCI BusWalk done
PCI bus and device discovery complete.
INI 8803 SYS BD PCI alloc done
Done allocating address space for PCI
devices.
INI 8804 SYS BD PCI config done
Done configuring PCI devices.
WRN 881
r
IO BD R2PCI
r not found
Rope-to-PCI bridge r not found.
FLT 881
r
IO BD R2PCI r not found
Rope-to-PCI bridge r not found.
WRN 882
r IO BD R2PCI r not found
Rope-to-PCI bridge r initialization failed.
FLT 882
r
IO BD Rope
r init err
Rope-to-PCI bridge r initialization failed.
WRN 883 r IO BD Rope r config err
PCI configuration failed below
Rope-to-PCI bridge r.
FLT 883
r
IO BD Rope
r config err
Rope r configuration failed.
INI 884
r EXT IO Rope r debug tggl
Rope r debug register toggled.
FLT 884 r EXT IO Rope r tgl fail
Rope r debug register toggle failed.
INI 8850 SYS BD early rope0 init
Initializing rope 0 for early RS-232
output.
FLT 8850 SYS BD rope0 init fail
Couldn’t initialize rope 0.
INI 8860 SYS BD rope0 init done
Rope 0 initialization complete.
INI 8870 IO BD early R2PCI init
Initializing Rope-to-PCI bridge 0 for early
RS-232 output.
FLT 8870 IO BD R2PCI init fail
Couldn’t initialize Rope-to-PCI bridge 0.
INI 8880 IO BD R2PCI init done
Rope-to-PCI bridge 0 initialization
complete.
INI 8890 IO BD early Super init
Initializing Super-I/O for early RS-232
output.
FLT 8890 IO BD Super init fail
Couldn’t initialize Super-I/O.
INI 88A0 IO BD Super init done
Super-I/O initialization complete.
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU Message
Description