Programming instructions

Chapter 3 59
Troubleshooting
Selftest Failures
FLT 3
n
09 SYS BD bad sys mde byte
CPU n detected an unsupported system
mode.
WRN 3
n
1A SYS BD hversion mismtch
Stable store hardware version doesn’t
match system.
TST 3
n
1B SYS BD chck model strng
Check model string with version in stable
store.
WRN 3
n
1B SYS BD model str msmtch
Model string doesn’t match that in stable
store.
FLT 3
n
1B SYS BD fatal model str
Error reading model string from stable
store.
TST 3
n
1C SYS BD test software ID
Check LANIC address.
WRN 3
n
1C SYS BD update sw ID
Update LANIC address.
FLT 3
n
1C SYS BD update sw ID err
Error updating LANIC address.
INI 3
n
2s SYS BD Invoke LDB:
s
CPU n is awaiting the low-level debugger
for s more seconds.
TST 3
n
BC IO BD test sys clocks
CPU n is verifying processor clocks with
the real-time clock.
INI 3
n
BC SYS BD init sys clocks
CPU n has initialized the processor clocks.
FLT 3
n
BC IO BD RTC tick timeout
The real-time clock is ticking too slowly or
not at all.
FLT 3
n
CD IO BD RTC tick timeout
The real time clock is ticking too slowly or
not at all.
TST 3
n
CD SYS BD check defaults
CPU n is initializing stable store values to
system defaults.
INI 3
n
CD SYS BD init defaults
CPU n finished initializing stable store
values.
FLT 3
n
CD SYS BD init EEPROM err
CPU n detected an error writing to stable
store.
FLT 3
n
EC SYS BD bad sys config
CPU n detected an illegal CPU board
configuration.
FLT 3
n
F4 SYS BD EEPROM boot limt
CPU n detected a fatal error writing the
EEPROM.
FLT 3
n
FC SYS BD bad sys bd id
CPU n cannot identify CPU board.
TST 4
n
00 SYS BD CPU
n start lst
CPU n is starting its late (with memory)
self-tests.
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU Message
Description