Programming instructions

Chapter 4 127
Field Replaceable Units
FRU Removal and Replacement
Speaker
This section explains how to remove and replace the speaker in the B2000 workstation.
The speaker is contained in the mounting bracket with the I/O fan. See Figure 4-53.
Figure 4-53. Location of the Speaker
Removing the Speaker
Perform the following steps to remove the speaker:
1. Open the left side panel of the workstation as shown in the section “Opening the Left
Side Panel.”
2. Remove the PCI retainer clip and all I/O cards. See the section “Removing I/O Cards” on
page 111.
3. Unscrew the two T-15 Torx screws that hold the workstation’s air divider in place, as
shown in Figure 4-54. Then grasp the edge of the air divider and pull it towards you to
remove it from the workstation.
Figure 4-54. Removing the Air Divider
Speaker
T-15 Torx
T-15 Torx
Air Divider
Screw
Screw