Programming instructions

Chapter 4 111
Field Replaceable Units
FRU Removal and Replacement
NOTE
If you are installing an additional HP V
ISUALIZE
-fxe graphics card, after you
connect the monitor to the additional graphics card, you must change the
graphics path for the monitor. To do this, see the section “Displaying and
Setting the Monitor Type” on page 150.
As shown in Figure 4-36, the four I/O slots as seen from the rear of the workstation are
labeled from top to bottom starting with 1.
Figure 4-36. I/O Slot Numbering
Removing I/O Cards
This subsection assumes that you already have I/O cards loaded in the workstation, and
that you need to remove one or more of them.
Perform the following steps to remove an I/O card:
1. Power off the workstation and unplug the power cord from the electrical outlet.
2. Attach the static-grounding wrist strap by following the instructions on the package.
Attach the sticky end of the wrist strap to bare metal on the rear panel of the
workstation.
3. Open the left side panel of the workstation as shown in the section “Opening the Left
Side Panel.”
4. Remove the PCI retainer clip by pulling evenly in the direction of the arrow on both
PULL tabs.
I/O Slot 1
I/O Slot 4
{