Programming instructions

Chapter 4 103
Field Replaceable Units
FRU Removal and Replacement
9. Rotate the workstation around until you see the open, left side of the workstation. Plug
the power and data cables into their connectors on the rear of the floppy disk drive, as
shown in Figure 4-23. Note that the connectors are keyed for proper insertion.
NOTE
The red striped side of the data cable should be positioned toward the power
cable.
Figure 4-23. Plugging in the Power and Data Cables
10.Make sure that the floppy disk drive’s power and data cables are positioned so that they
will come out of the top edge of the floppy disk drive bay’s rear cover when it is replaced.
(Note that the rear cover’s top edge is rounded to prevent cutting of the cables.) Put the
rear cover in place and tighten the T-15 Torx/slotted screw. Note that, when you replace
the rear cover, the ferrite bead on the data cable must remain inside of the floppy disk
drive bay’s rear cover. See Figure 4-24.
Figure 4-24. Replacing the Floppy Disk Drive Bay’s Rear Cover
11.Remove the plastic floppy disk drive blank from the workstation’s front panel, if
present.
12.Make sure that all cables are positioned within the workstation so that they cannot be
damaged. Then close the left side and front panels of the workstation as shown in the
sections “Closing the Left Side Panel” and “Closing the Front Panel.”
Power
Cable
Data Cable
Power Cable
Data Cable
T-15
Torx/Slotted
Screw
Rear Cover