Specifications

80 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

Left Side Panel

Closing the Left Side Panel

Perform these steps to close the left side panel.

1. Hold the left side panel so that the top and bottom hinge hooks can be

inserted into their hinge slots. See Figure 4-2. Note that the hinge

slots are located on the far right edge of the workstation (using the

back of the workstation as the reference).

2. Swing the back edge of the panel toward the workstation’s back edge

and press the outside edges of the side panel tightly against the

workstation. This will ensure a tight seal of the EMI gaskets.

3. Secure the side panel in place and tighten the two T-15 Torx

thumbscrews you previously removed.