Specifications

Chapter 4 77
Changing Your Workstation’s Hardware Configuration
Front Panel
Figure 4-1 Opening the Front Panel
4. Swing the panel outward on its left snap hinges until the panel comes
free and place the front panel in a location where it cannot get
broken.
Closing the Front Panel
Perform the following steps to close the workstation.
1. Locate the hinges on the left side of the front panel, and insert them
into the holes located along the left edge of the workstation.
2. Rotate the front panel inward until you hear the two latch buttons
snap in place. The front panel is now closed. If there is a need to lock
the front panel, use the keys that came with your workstation to lock
the panel. These keys are located inside the front bezel below the
floppy disk drive.
3. Plug in the workstation’s power cord, and power on the workstation.
Bezel Latch
Button
Bezel Latch
Button