Specifications

Chapter 1 25
Overview
Product Information
USB Connectors
The USB connectors located on the rear panel of the workstation provide
and interface for the keyboard ad mouse to the system. These USB
connectors support only the HP keyboard, HP mouse and USB hub. The
keyboard and mouse may be plugged into either USB connector on the
rear of the workstation or plugged into the USB hub. No other USB
configuration is currently supported. Consult the documentation that
accompanies each input device for specific information concerning its
use.
For more information on USB, see the Universal Serial Bus website at
the following URL:
http://www.usb.org
The following subsections briefly describe each of the three USB devices
you can connect to the B2000 workstation’s USB connectors. The mouse
and keyboard were shipped with your workstation, and the USB hub can
be ordered separately.
CAUTION Usage of devices other than USB specification may result in
unpredictable functionality and inferior performance of the B2000
workstation.
NOTE The USB cable clip on the rear of the chassis provides strain relief for the
USB cables. Open the cable clip, loop the cables through the clip and
snap it closed to secure the USB cables. See Figure 1-3 on page 23.
HP USB Keyboard
The HP USB keyboard provides the standard keycaps found on most PC
keyboards.
NOTE The USB keyboard and mouse may be plugged into either USB connector
on the rear of the B2000 workstation.