Specifications

140 Chapter4
Changing Your Workstation’s Hardware Configuration
Memory Cards
2. Press downward on the ejector tabs located on both sides of the
DIMM connector. See Figure Figure 4-52. This raises the DIMM card
for easy extraction.
Figure 4-52 Removing Memory Cards
3. Lift up evenly on the outside edges of the DIMM card to remove it.
See Figure 4-52.
4. Install the remaining DIMM cards in the correct order. See Figure
4-47 or the system label.
5. Replace the left side panel as explained in the section “Replacing the
Left Side Panel” in this chapter. Plug the power cord back in to the
electrical outlet.
6. Verify that this removal was successful by following the steps in
Chapter 5, “The Boot Console Interface.” Note that you can also use
SAM and select the Performance Monitor icon, then the System
Properties icon, and in the window that appears, select the tab
labeled Memory.
Notches
Ejector Tab