Specifications

136 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

Memory Cards

4. Press downward on the ejector tabs located on both sides of the

DIMM connector. See Figure 4-49. This opens the connector for

DIMM card insertion.

Figure 4-49 Installing Memory Cards

5. Place the DIMM card in the connector, lining it up with the guides.

Make sure you align the notches on the bottom edge of the DIMM

card with the DIMM connector keys. See Figure 4-49.

6. Press ﬁrmly and evenly on the DIMM card to ensure that it seats

properly.

NOTE The ejector tabs will return to the locked position when the DIMM card

is fully seated in the connector.

7. Replace the left side panel as explained in the section “Replacing the

left side panel” in this chapter. Plug the power cord back in to the

electrical outlet.

8. Verify that this installation was successful by following the steps in

the section “Displaying the Current Memory Conﬁguration” on page

173 in Chapter 5, “The Boot Console Interface.”

Notches

Black

Ejector Tab

White

Ejector Tab

Press down on ejector tabs to

open them and place the

DIMM card in the connector

so that your ﬁngers are on

the edge of the DIMM card.

Push the DIMM card down

ﬁrmly and evenly into the

connector to be sure it is

properly seated.

Step 2

Step 1