Specifications

114 Chapter4
Changing Your Workstation’s Hardware Configuration
Removable Media Devices
7. Tighten the two floppy disk bracket screws as shown in Figure 4-34.
Figure 4-34 Tightening the Bracket Screws
8. Make sure that the floppy data and power cables are positioned so
that they come out of the top edge of the rear floppy disk drive bay’s
cover. This edge is rounded to prevent cutting of the cables. See
Figure 4-35. Put the rear cover in place and tighten the T-15
Torx/slotted screw.
Figure 4-35 Replacing the Rear Floppy Disk Drive Bay’s Cover
9. Replace the plastic floppy disk drive blank in the workstation’s front
Bracket Screw
Bracket Screw
T-15
Torx/slotted
Screw
Power
Cable
Rear Cover
Data Cable
Rear Cover Handle