HP FlexFabric Virtual Switch 5900v Troubleshooting Guide

Figure 3 Plug-in registration status

The icon indicates that the plug-in has been successfully installed. The icon indicates that the

plug-in has been removed. To install the plug-in, click Install.

Verifying link aggregation configuration

1. Verify the physical NICs that connect the server to the EVB switch, and the ports that connect the

EVB switch to the server.

2. On the server side, enter the link aggregation configuration page on the vSphere client to verify

link aggregation configurations of the ports on the server, as shown in Figure 4:

{ Verify that the link aggregation mode is Static.

{ Verify that the load balancing mode is Source MAC or Destination MAC.

{ Verify that all aggregation interfaces are the same type and same rate.

{ Verify that all physical ports to be aggregated are selected.

Figure 4 Link aggregation configuration page

3. On the EVB switch, execute the display link-aggregation verbose command in system view to

verify aggregation interface configuration:

<Sysname> display link-aggregation verbose

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Port Status: S -- Selected, U -- Unselected

Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,

D -- Synchronization, E -- Collecting, F -- Distributing,

G -- Defaulted, H -- Expired

Aggregate Interface: Bridge-Aggregation100

Aggregation Mode: Static

Loadsharing Type: Shar

Port Status Priority Oper-Key

--------------------------------------------------------------------------------

XGE1/0/15 S 32768 4

XGE1/0/29 S 32768 4