User's Manual

Virtual Connect networks 114
To configure a port for polling:
1. Select the Configure checkbox under Polling.
2. Use the arrows to select a polling interval.
3. Use the pull-down arrow to select a receiver.
When you are finished editing the port, click OK.
There are several options to view available ports:
• Use the Show pull-down menu to show All, Configured Ports, or Unconfigured ports.
• Select the checkbox next to each port you want in your list, and then select the Show only selected ports
checkbox at the bottom of the table to display only the ports that are selected.
You can then filter the ports that are shown. The available filter selections are dependent on the list of ports
that are shown. For example, a list of unconfigured ports does not allow you to filter by a receiver because
there are no receivers assigned to unconfigured ports.
You can filter by:
• Selected receiver, sampling ports, or polling ports
• All enclosures or individual enclosures
• All bays or individual bays
Click Apply to save any changes on this screen.
IGMP Settings (IGMP Configuration) screen
From this screen you can do the following:
• Enable or disable IGMP Snooping (on page 115)
• Modify the idle timeout interval for IGMP Snooping
• Allow or prevent flooding of unregistered IGMP multicast traffic