Release Notes

Prerequisites 9
The VCM GUI does not redirect to the correct IP after a VC failover.
Workaround
The next failover succeeds without any issues. Refreshing the browser or closing and opening a new
session redirects the browser to the correct IP address.
Issue
Errors are received when changing an FCoE network to a different module in a VCEM environment.
Workaround
The customer must revert the changes, and then complete or cancel the domain maintenance mode. If
the uplink must be changed to a different module, the customer can delete the existing network, and
then re-create the network with the same name, but use different uplinks.
Issue
Under certain circumstances, the checkpoint status icon in the GUI persists for a long time and is not cleared.
The CLI also shows a "Checkpoint Status: Invalid" status in the show domain command output. This condition
occurs periodically after a VCSU firmware upgrade of the VC module firmware.
Workaround
To resolve this issue, reset VCM on the primary module or reset the primary module using the OA.
Prerequisites
• VC SR-IOV prerequisites:
o Supports the following adapters:
— HP Flex-10 10Gb 2-port 530FLB Adapter
— HP FlexFabric 10Gb 2-port 534FLB Adapter
— HP Flex-10 10Gb 2-port 530M Adapter
— HP FlexFabric 10Gb 2-port 534M Adapter
— HP NC552m Flex-10 Adapter
— HP NC553m 10Gb 2-P FlexFabric Converged Network Adapter
— HP FlexFabric 10Gb 2-port 554M Adapter
— HP Flex-10 10Gb 2-port 552M Adapter
— HP FlexFabric 10Gb 2-port 554FLB Adapter
— HP FlexFabric 20Gb 2-port 630FLB Adapter
— HP FlexFabric 20Gb 2-port 630M Adapter
o Supports the following operating systems:
— Windows 2012 (64-bit)
— VMware ESXi 5.1 U2, 5.5 (64-bit)
— RHEL 5.9 and 5.10 (64-bit with KVM)
— RHEL 6.4 and 6.5 (64-bit with KVM)