User's Manual

Introduction 6
Introduction
What's new
The following changes have been implemented for VC 4.30/4.31:
• Features:
o Support for FIPS 140-2
For information on a current certification status, see the HP website
(http://government.hp.com/Certifications.aspx).
o SNMPv3
o Configure partially stacked domains
o Monitor uplink and stacking link ports for pause flood conditions
o Increased VLAN capacity
o UEFI support
• Added a new snmp-user (on page 122) managed element.
• Enhanced the following SNMP commands to support SNMPv3:
o snmp (on page 116)
o snmp-trap (on page 118)
• Enhanced the set stackinglink ("stackinglink" on page 130) command to allow
configuration of partially stacked domains.
• Enhanced the VlanCapacity property of the enet-vlan command to support more VLANs:
enet-vlan (on page 37)
• Enhanced the following commands to display the domain stacking mode or provide warning or notice
when configuring ports that are controlled by the domain stacking mode:
o show stackinglink ("stackinglink" on page 130)
o show config ("config" on page 24)
o add uplinkport ("uplinkport" on page 139)
o add port-monitor ("port-monitor" on page 85)
o add sflow-ports ("sflow-ports" on page 112)
• Enhanced the show uplinkport ("uplinkport" on page 139) command to display ports
controlled by the domain stacking mode as disabled.
• Enhanced the bootMode property of the profile element to support UEFI:
add profile ("profile" on page 88)
• Added a pxeBootOrder property to the enet-connection element to allow configuration of the
PXE IP boot order:
enet-connection (on page 33)