User's Manual

Introduction 10
# Set the domain default LACP timer to the short setting (one second)
set lacp-timer default=Short
# Add a Multicast Filter "filter1" to Filterset "mfs1"
add mfs-filter FilterSet=mfs1 McastFilter =filter1
# Set the global option to enable the loop protection and pause flood protection
set port-protect networkLoop=Enabled PauseFlood=Enabled
# Set idle user sessions to expire after 20 minutes of inactivity
set session Timeout=20
# Create a new Multicast Filter and adds it to the domain
add mcast-filter MyMcastFilter
# Assign a profile to a device bay
assign profile MyProfile enc0:1
# Done!!!
Virtual Connect overview
HP Virtual Connect is a set of interconnect modules and embedded software for HP BladeSystem c-Class
enclosures. VC implements server edge virtualization between the server and the data center infrastructure so
networks can communicate with individual servers or pools of HP BladeSystem server blades. Upgrade,
replace, or move server blades within the enclosures without visible changes to the external LAN and SAN
environments. The external networks connect to a shared resource server pool rather than to individual
servers. VC cleanly separates server enclosure administration from LAN and SAN administration. VC
simplifies the setup and administration of server connections and includes the following components:
• HP Virtual Connect Manager
• VC-Enet modules:
o HP VC Flex-10 10Gb Ethernet Module for BladeSystem c-Class
o HP VC FlexFabric 10Gb/24-port Module for BladeSystem c-Class
o HP VC FlexFabric-20/40 F8 Module for BladeSystem c-Class
o HP VC Flex-10/10D Module for BladeSystem c-Class
NOTE: Using a Flex-10 capable NIC with an HP VC Flex-10 or FlexFabric module provides the
ability to divide a 10Gb NIC into four FlexNICs with configurable bandwidth.
• VC-FC modules: