Installation guide
1. Run kdmconfig.
2. Use the Change Keyboard option to change the keyboard type.
3. Save the conguration.
■
If your system is running the default Xorg server, follow these steps:
1. Run kdmconfig.
2. Select the Xsun server.
3. Use the Change Keyboard option to change the keyboard type.
4. Save the conguration.
5. Run kdmconfig again to switch to the Xorg server.
SPARC: jfca Driver for Certain Host Bus AdaptersThat
Are Connected to Tape Devices Might Cause Errors
(6210240)
The jfca driver for the following host bus adapters (HBAs) might cause system panics or I/O
failures when these HBAs are connected to tape devices:
■
SG-PCI1FC-JF2
■
SG-PCI2FC-JF2
The jfca driver for these HBAs is prone to race conditions when certain operations are being
run, and thus causes the errors. The operations are the following:
■
Link reset
■
Loop reset
■
Switch reset
■
Repeated link failures
Error messages similar to the following examples might be displayed:
■
I/O failure messages
jfca: [ID 277337 kern.info] jfca4: Sequencer-detected error. Recover
immediately.
last message repeated 18376 times
jfca: [ID 716917 kern.notice] jfca4: ExgWarning: SendVerify(1): SHOULD
ABORT THE ORIG I/O PKG=30007520bd8!
scsi: [ID 107833 kern.warning] WARNING:
/pci@1e,600000/SUNW,jfca@3,1/fp@0,0/st@w2100001086108
628,1 (st3):
SCSI transport failed: reason ’timeout’: giving up
■
System panic message
Hardware–Related Issues and Bugs
Solaris 10 10/09 Release Notes • October 200974