Installation guide
mpathadm Does Not Display Load-Balance Setting
Specic to Device
The mpathadm show logical-unit subcommand lists the load balancing global conguration
value for the Current Load Balance property. However, entries in the csi_vhci.conf that
change the load-balance type for a specic product are not reected in the mpathadm output
even when the setting is active.
Registration Tool Prevents Power Management on
Some Framebuers (6321362)
If the background processes for the registration tool are left running, the Elite3D and
Creator3D framebuers stop power management. This failure reduces the power savings when
the system is in a power-managed state. Under certain conditions, sys-suspend might also hang.
No error message is displayed. The system might hang during a system suspend or resume
operation.
Workaround:
Run the following command approximately 60 seconds after each login:
# pkill -f basicreg.jar
# pkill -f swupna.jar
SPARC: Sun Crypto Accelerator 4000 BoardVersions
1.0 and 1.1 Not Supported in Solaris 10 OS
A new cryptographic framework is provided in Solaris 10 OS. However, versions 1.0 and 1.1 of
the Sun Crypto Accelerator 4000 board's software and rmware do not utilize this framework.
Consequently, these versions are not supported in the Solaris 10 OS.
The 2.0 release uses the new framework. This release is available as a free upgrade to current Sun
Crypto Accelerator 4000 users who plan to use Solaris 10 OS. Because the Sun Crypto
Accelerator 4000 is an export-controlled product, you must contact Sun Enterprise Services or
your local sales channel to obtain the free upgrade. Additional information is available on the
Sun Crypto Accelerator 4000 web page at Sun's
products site.
Certain USB 2.0 Controllers Are Disabled
Support for certain USB 2.0 controllers has been disabled because of incompatibilities between
these devices and the EHCI driver. The following message is displayed:
Hardware–Related Issues and Bugs
Chapter 2 • Solaris Runtime Issues 71