Installation guide

9. At the end of the installation, reboot the system. Repeat steps 1 through 7.
10. To make this change permanent so that the above steps do not need to be repeated for
subsequent boots, do the following:
Become the super user, when the system boot is completed.
11. Open the /etc/system le.
12. Add the following line:
set use_mp = 0
■
Workaround 5: Disable microcode update. Type the following command:
# mv /platform/i86pc/ucode /platform/i86pc/ucode.disabled
Microcode update can be invoked manually after the system is up:
# ucodeadm -u /platform/i86pc/ucode.disabled/intel-ucode.txt
zoneadm install Fails With a ZFS Legacy Mount
(6449301)
If a non-global zone is initially congured with a ZFS le system to be mounted with the `add
fs subcommand and species mountpoint=legacy, the subsequent zone installation fails. The
following error message is displayed.
ERROR: No such file or directory:
cannot mount </zones/path/root/usr/local> in non-global zone to install:
the source block device or directory </path/local> cannot be accessed
Workaround: Add access to a ZFS le system after installing the non-global zone.
ZFS and UNIX/POSIX Compliance Issues
ZFS is designed to be a POSIX compliant le system and in most situations, ZFS is POSIX
compliant. However, two edge case conditions exist when ZFS does not meet the POSIX
compliance tests:
1. Updating ZFS les system capacity statistics.
2. Modifying existing data with a 100 percent full le system.
Related CRs:
■
6362314
■
6362156
File Systems
Solaris 10 10/09 Release Notes • October 200960