Installation guide

cfgadm: Hardware specific failure: connect failed:
board is disabled: must override with [-f][-o enable-at-boot]
To override the disabled condition, two options are available:
■
Using the force ag (-f)
# cfgadm -f -c connect sysctrl0:slot number
■
Using the enable option (-o enable-at-boot)
# cfgadm -o enable-at-boot -c connect sysctrl0:slot
number
To remove all boards from the disabled board list, choose one of two options depending on the
prompt from which you issue the command:
■
From the superuser prompt, type:
# eeprom disabled-board-list=
■
From the OpenBoot PROM prompt, type:
OK set-default disabled-board-list
For further information about the disabled-board-list setting, refer to the “Specic NVRAM
Variables” section in the Platform Notes: Sun Enterprise 3x00, 4x00, 5x00, and 6x00 Systems
manual. This manual is part of the documentation set in this release.
Disabled Memory List
Information about the OpenBoot PROM disabled-memory-list setting is published in this
release. See “Specic NVRAM Variables” in the Platform Notes: Sun Enterprise 3x00, 4x00,
5x00, and 6x00 Systems in the Solaris on Sun Hardware documentation.
Unloading Detach-Unsafe Drivers
If you need to unload detach-unsafe drivers, use the modinfo line command to nd the module
IDs of the drivers. You can then use the module IDs in the modunload command to unload
detach-unsafe drivers.
Dynamic Reconguration on Sun Enterprise Midrange Systems
Solaris 10 10/09 Release Notes • October 2009116