Installation Guide

Chapter 6. Administration of the Telecommuting Module
Save to diskette
Insert a formatted diskette into the Telecommuting Module’s floppy drive and press Save to diskette to save the
preliminary configuration. Do not remove the diskette until the light on the floppy drive goes out.
Check that you get a confirmation of the saving. If not, the diskette may be faulty.
Load from diskette
Insert the diskette with the saved configuration into the Telecommuting Module’s floppy drive and press Load from
diskette. Do not remove the diskette until the light on the floppy drive goes out. The contents of the diskette are
now loaded in the preliminary configuration.
Save to local file
Press Save to local file to save the preliminary configuration to the file you have selected. A new window is opened
where you enter the name of the file.
Load from local file
Press Load from local file to load a new preliminary configuration from the file you have selected.
Browse
Browse is used to scan your local disk. The web browser opens a new window where you can search among files
and directories. Go to the right directory and select the file you want to upload.
Revert to old configurations
You can revert to old configurations of the Telecommuting Module, either back to the last configuration
successfully applied, or to the configuration delivered with your Telecommuting Module from the factory.
Abort All Edits
Abort all edits copies the permanent configuration to the preliminary configuration. All changes made in the
preliminary configuration are deleted.
Reload Factory Configuration
The factory configuration is the standard configuration that is delivered with a Telecommuting Module. Click on
this button to load this configuration into the preliminary configuration. The permanent configuration is not affected.
35