Installation Guide

Chapter 4. Network Configuration
Routed network
Enter the DNS name or IP address of the routed network under DNS name or network address.
The IP address of the routed network is shown under Network address.
In the Netmask field, enter the netmask of the network.
Router
The name or IP address of the router that will be used for routing to the network. If there are several routers
between the Telecommuting Module and the network, fill in the router closest to the Telecommuting Module.
Delete Row
If you select this box, the row is deleted when you click on Add new rows, Save, or Look up all IP addresses
again.
Create
Enter the number of new rows you want to add to the table, and then click on Create.
Save
Saves all Interface configuration to the preliminary configuration.
Cancel
Clears and resets all fields in new rows and resets changes in old rows.
Look up all IP addresses again
Looks up the IP addresses for all DNS names on this page in the DNS servers you entered on the Basic
Configuration page.
Networks and Computers
Here, you name groups of computers and networks. Sometimes it can be useful to give a group of computers a
network name, such as Administration. If you want to group some computers, this can be done here, even if they do
not have consecutive IP addresses. You can also include a subgroup when defining a new network group.
The names are used when you configure Surroundings and SNMP.
Every group of computers which can reach each other without having to pass through the firewall needs a separate
network group.
The rows are sorted in alphabetical order, except that all upper case letters are sorted before lower case letters (B
comes before a).
22