Installation Guide

Chapter 4. Network Conﬁguration

DNS name or IP address

Enter the DNS name or IP address for the default gateway. If an interface will receive its IP address from a DHCP

server, the Telecommuting Module will get its default gateway from the server, and Default Gateway must be set to

"*".

IP address

Shows the IP address of the DNS name or IP address you entered in the previous ﬁeld.

Gateway Reference Hosts

The gateway reference hosts are used by the Telecommuting Module to check if the gateways are alive. For each

reference host, test ping packets are sent, using the different gateways.

Reference hosts are only needed when multiple default gateways are used.

DNS name or IP address

Enter the DNS name or IP address for the reference host. The reference host must be located on the other side of the

default gateway.

IP address

Shows the IP address of the DNS name or IP address you entered in the previous ﬁeld.

DNS Servers

Here, you conﬁgure DNS servers for the Telecommuting Module. The servers are used in the order they appear in

this table, which means that the Telecommuting Module uses the top server to resolve DNS records until it doesn’t

reply. Only then is server number two contacted.