Administrator's Guide

Chapter 6. Basic Conﬁguration

Dynamic

If an interface will receive its IP address from a DHCP server, the Telecommuting Mod-

ule can also get information about its DNS server from that server. In this case, select the

corresponding IP address here and leave the other ﬁelds empty.

DNS Name Or IP Address

The DNS name/IP address of the DNS server which the Telecommuting Module should use.

Note that to use DNS names here, there must exist a DNS server in the Telecommuting

Module’s permanent conﬁguration.

IP address

Shows the IP address of the DNS Name Or IP Address you entered in the previous ﬁeld.

Delete Row

If you select this box, the row is deleted when you click on Create new rows, Save, or Look

up all IP addresses again.

Create

Enter the number of new rows you want to add to the table, and then click on Create.

Save

Saves the Basic Conﬁguration conﬁguration to the preliminary conﬁguration.

Cancel

Reverts all the above ﬁelds to their previous conﬁguration.

Look up all IP addresses again

Looks up the IP addresses for all DNS names on this page in the DNS servers you entered

above.

Access Control

On the Access Control page, settings are made which controls the access to the Telecom-

muting Module administration interfaces. The Telecommuting Module can be conﬁgured

via the web (http and https) and via ssh or the serial cable (using the CLI, see chapter 18,

Command Line Reference).

Select one or more conﬁguration IP addresses for the Telecommuting Module. The conﬁg-

uration address is the IP address to which you direct your web browser to access the web

interface of the Telecommuting Module, or connect your ssh client to.

For each network interface, you also specify whether or not the Telecommuting Module can

be conﬁgured via this network interface.