Administrator's Guide

Chapter 8. Network Configuration
Create
Enter the number of new rows you want to add to the table, and then click on Create.
Save
Saves the Default Gateway configuration to the preliminary configuration.
Cancel
Clears and resets all fields in new rows and reset changes in old rows.
Interface (Network Interface 1 and 2)
There is a page for each network interface (Network Interface 1 and 2) on the Telecommuting
Module. Select a page to make configuration for that interface. There is also a page where
configuration for all interfaces can be viewed and changed.
Here, you set the interface name, whether the interface is on or off, the IP address, alias, and
static routing.
For each interface, go to Directly Connected Networks and state the IP address of the
Telecommuting Module and the size of the network connected to this interface.
General
Physical device
Physical device tells the physical device name of the network interface.
Status
Specify if this network interface is On or Off. If the interface is off, all configuration on
this page is ignored, and the Telecommuting Module will behave as if this interface wasn’t
present.
Interface name
The network Interface name is only used internally in the Telecommuting Module, e. g.
when configuring Networks and Computers.
124