Administrator's Guide

Chapter 7. Administration
Browse
Browse is used to scan your local disk. The web browser opens a new window where you
can search among files and directories. Go to the right directory and select the file you want
to upload.
Revert to Old Configurations
You can revert to old configurations of the Telecommuting Module, either back to the last
configuration successfully applied, or to the configuration delivered with your Telecommut-
ing Module from the factory.
Abort All Edits
Abort all edits copies the permanent configuration to the preliminary configuration. All
changes made in the preliminary configuration are deleted.
Reload Factory Configuration
The factory configuration is the standard configuration that is delivered with a Telecommut-
ing Module. Click on this button to load this configuration into the preliminary configuration.
The permanent configuration is not affected.
Show Configuration
Shows both the preliminary and permanent configurations, in that order. Before the prelim-
inary configuration, you see the Telecommuting Module’s version, serial number, the time
zone and table format you selected.
If there are any differences between the preliminary and the permanent configuration, the
message "This setting has been changed but not applied." will be shown in red at the setting
in question, in the Preliminary section. If there are any errors in the preliminary configura-
tion, this will also be marked in red in the Preliminary section.
The heading before each table for the preliminary configuration is clickable and accesses the
corresponding configuration page.
Print this list from your web browser and store it in a safe place.
106