Administrator's Guide

Chapter 7. Administration
Save to diskette
Insert a formatted diskette into the Telecommuting Module’s floppy drive and press Save to
diskette to save the preliminary configuration. Do not remove the diskette until the light on
the floppy drive goes out.
Check that you get a confirmation of the saving. If not, the diskette may be faulty.
Load from diskette
Insert the diskette with the saved configuration into the Telecommuting Module’s floppy
drive and press Load from diskette. Do not remove the diskette until the light on the floppy
drive goes out. The contents of the diskette are now loaded in the preliminary configuration.
Save to local file
Press Save to local file to save the preliminary configuration to the file you have selected. A
new window is opened where you enter the name of the file.
Load from local file
Press Load from local file to load a new preliminary configuration from the file you have
selected.
Browse
Browse is used to scan your local disk. The web browser opens a new window where you
can search among files and directories. Go to the right directory and select the file you want
to upload.
Save/Load CLI Command File
All configurations can be saved to and loaded from a CLI file (see chapter 18, Command
Line Reference, for more information about the CLI). You can also edit the CLI file before
it is uploaded again.
Uploading a CLI file might affect the permanent configuration, as the CLI file can contain
commands that applies the configuration.
Save config to CLI file
Press Save config to CLI file to save the preliminary configuration to the file you have
selected. A new window is opened where you enter the name of the file.
Load CLI file
Press Load CLI file to upload a CLI file to the Telecommuting Module.
105