User Manual

Setting up the monitor
Installing the monitor stand
CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of
color or disorientation of the liquid crystals. If this occurs, the screen will not recover to its normal condition.
1. Insert the monitor stand into the base (1).
2. Tighten the thumbscrew on the bottom of the base (2).
Connecting the cables
NOTE: The monitor ships with select cables. Not all cables shown in this section are included with the
monitor.
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Before connecting the cables, route the cables through the cable routing hole in the center of the stand.
3. Connect a video cable to the video input connector.
Setting up the monitor 5