Application Guide

Run the Quick Test
The System Quick Test performs a quick check of your system to make sure that the main
components are functioning properly.
note:
The Quick Test is not available in the Windows version of the diagnostic tests.
The following tests are performed.
 Battery check
 Processor check
 System board check
 Hard drive SMART check
 Hard drive short DST check
 Memory quick check
You cannot use your computer during the test. This test takes 10 to 15 minutes or more to
complete, depending on the system configuration. You can cancel at any time by pressing the
Escape key (Esc).
Use the following steps to run the Quick Test.
1. From the main menu, click System Tests, and then click Quick Test.
Figure : Selecting the Quick Test
2. Click Run once.
While the test is running, the time remaining and test result for each component are
shown on the screen. The test can take up to 15 minutes.