User's Manual

Confi gure and ver
ify the host
Verifying configuration settings
Verify that all paths to the storage system are p resent with cfgadm -al command. To display the LUNs
configured to each path, execute cfgadm -al -o show_FCP_dev asshownintheexamplebelow.
The following examples are with 4 pa ths (ports) visible from the array on the host and with 2 LUNs
configured on the array for the host. You should normally see 4 paths with EVA3000/ EVA5000/
EVA4000/ EVA6000, however you might also see up to 8 paths with EVA8000.
1. Enter the cfgadm command to verify the p aths to the LUNs (note that you need to h ave
configured LUNs on the array for the host in order to see the “ disk” lines):
Example: # cfgadm -al -o show_FCP_dev
Ap_Id Type Receptacle Occupant Condition
c2 fc-fabric connected unconfigured unknown
c2::50001fe1002709f8,0 array-ctrl connected unconfigured unknown
c2::50001fe1002709f8,1 disk connected unconfigured unknown
c2::50001fe1002709f8,2 disk connected unconfigured unknown
c2::50001fe1002709fc,0 array-ctrl connected unconfigured unknown
c2::50001fe1002709fc,1 disk connected unconfigured unknown
c2::50001fe1002709fc,2 disk connected unconfigured unknown
c3 c-fabric connected unconfigured unknown
c3::50001fe1002709f9,0 array-ctrl connected unconfigured unknown
c3::50001fe1002709f9,1 disk connected unconfigured unknown
c3::50001fe1002709f9,2 disk connected unconfigured unknown
c3::50001fe1002709fd,0 array-ctrl connected unconfigured unknown
c3::50001fe1002709fd,1 disk connected unconfigured unknown
c3::50001fe1002709fd,2 disk connected unconfigured unknown
With Solaris 8 or 9, the Occupant status will be displayed as above in a SAN environment. With
Solaris 10 (SPARC and x86), you will see a configured status.
2. For Solaris 8 and 9 , use cfgadm -c configure c# command to configure the host to
access the storage system as shown in the example below. The value of # is gathered from the
output of the cfgadm -al previously executed.
Example:
# cfgadm -c configure c2
# cfgadm -c configure c3
3. Execute the cfgadm command to view configured devices. After the configuration, the following
command will show the array controllers as configured:
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 disk connected configured unknown
c0::dsk/c0t6d0 CD-ROM connected configured unknown
c1 scsi-bus connected unconfigured unknown
c2 fc-fabric connected configured unknown
c2::50001fe1002709f8 array-ctrl connected configured unknown
c2::50001fe1002709fc array-ctrl connected configured unknown
c3 fc-fabric connected configured unknown
c3::50001fe1002709f9 array-ctrl connected configured unknown
c3::50001fe1002709fd array-ctrl connected configured unknown
6