HP Tru64 UNIX Technical Updates for the Version 5.1B and Higher Operating System and Patches (February 2010)

To work around this problem, install the software as follows:
1. Perform the upgrade by rolling Version 5.1B and NHD6. Complete the roll, including all
clean up steps.
2. Roll NHD6 (again) and Patch Kit 2, making sure you roll NHD6 first.
3. After you invoke ./nhd_install, the following message and prompt will appear:
Using kit at /mnt/540
NHD version 542 is already installed
Do you really want to install it again (y or n)
Enter y followed by a carriage return.
4. Install Patch Kit 2 using dupatch, and perform the steps to complete the roll.
This problem will be corrected in the NHD7 release.
Patch Kit 1
The following notes pertain to Patch Kit 1.
File Permission Error Caused by /etc/.mrg..protocols.sh script (Apr. 2003)
The installation of this kit causes a problem with the /etc/.mrg..protocols.sh script, in
which the script creates a temporary protocols file in /tmp and moves it to /etc instead of
copying it to /etc. The result is a change in the file permission for /etc/protocols; for
example, the permission might change from 755 to 600.
The workaround is to check and, if necessary, change the permissions on /etc/protocols
after installing Patch Kit 1.
Enabling envmond on AlphaServer ES47/ES80/GS1280 systems (Mar. 2003)
After installing this patch kit, the envmond daemon will be disabled on ES47, GS80, and GS1280
AlphaServers..
To enable environmental monitoring, change the entry ENVMON_CONFIGURED=0 to
ENVMON_CONFIGURED=1 in the /etc/rc.config file. You can do this using one of the following
commands:
/usr/sbin/envconfig -c ENVMON_CONFIGURED=1
/usr/sbin/rcmgr set ENVMON_CONFIGURED 1
Problems with /sbin/dsfmgr Versions (Mar. 2003)
See “Problems with /sbin/dsfmgr Versions (Mar. 2003)” for details.
Documentation Error in Release Notes (Feb. 2003)
In Section 1.1.5 of the release notes that shipped with kit, the reference to “audit's -m switch” is
incorrect. The reference should be to the auditd -d option. The workaround to the problem
described in that section should read as follows:
“...boot to single-user mode and remove the -d option from the audit configuration stored in
/etc/rc.config.common or /etc/rc.config. “
Message when Installing ssh V3.2 (Jan. 2003)
When you install ssh V3.2 (Patch 389.00) you may see a message similar to the following. You
can ignore this message:
AllowCshrcSourcingWithSubsystems is not valid
ForcePTTYAllocation is not valid
IdentityFile is not valid
AuthorizationFile is not valid
Secure Shell daemon (sshd2) started.
Patch Kit Updates 23